How to Speed Controller Spindle for CNC Hardware Setup
Mechanical

How to Speed Controller Spindle for CNC Hardware Setup

How to Speed Controller Spindle for CNC Hardware Setup

Dear friend lets know how to set up spindle motor speed control in CNC Machine,

Detail 4131 103 ep potentiometer IC  use as 10k Potentiometer resistance

VDD = Positive power supply  1.8 to 5.5 Voltage

PBO = Resistance face B side (Link in VFD (Variable Frequency Drive) V1I point)

PAO = Resistance face Aside or (Link in VFD (Variable Frequency Drive) V1I point)

PWO = Resistance wiper (Link in VFD (Variable Frequency Drive) Gnd point)

VSS = Negative power supply  1.8 to 5.5 Voltage

CS =   Chip Select (SPI port chip select pin used to execute a new command after it has been loaded into the shift register) this point connected in CNC Controller out point without relay

SCK = SCK is the Shared/Serial Clock. It is the SPI clock line. this point connected in CNC Controller out point without relay

4031 chip

How to connection CNC controller to VFD Connection

Mach3 CNC Controller to a spindle  speed control

How to Connection CNC Controller (Mach3) to 4131  photometers digital 10k IC?

VFD connrction

Spindle Speed control   hardware confirmation

Mach3 interface board connection output point Below a detail

Step 1: Connect mach3 board PWM output in 4131 ic SCK pin no 3

Step 2: Next connection 4131 ic pin no 1 connect to Mach3 interface board  GND point

Step 3: let’s go and connect ic VSS pin no 4 negative 5v power  supply from Mach3 Interface board

All the above point connection between the Mach3 interface to 4131 resistance  IC

How to Connection  4131  (Potentiometer) digital 10k IC to VFD (Variable Frequency Drive)?

Step 4: In 4131 ic pin no 8 Postive 5v power supply from Mach3 interface board

Our VFD Drive knows much output and input. So we are sure that use the only 10 k Resistance (Potentiometer) point.   A, W, B point is an out Potentiometer resistance below ming of the point

A = This fix pin in VFD attach this one end of the resistive point (A point resistive)

W=This fix pint in VFD attach this second end of the wiper point (W point Call wiper)

B= This fix pin in VFD attach this third end of the resistive point (B point resistive)

Resistance

 

Step 5: Let’s goPBO  pin no 7 in our potentiometer ic connection VFD output port B point of potentiometer

Step 6: PWO pin No 6 connection in VFD point W (Wiper) as the primary control point in speed controlling

 Step 7:  Now final point connection PAO  pin no 5 in our potentiometer ic connection VFD output port A point of potentiometer

 

Dear above all step Hardware setup of Mach3 CNC controller to VFD using of 4131 potentiometers.

This is the use of automatic speed control by the CNC controller.

This method also uses VFD speed control.

Also Read : IS CODE FOR CIVIL ENGINEER [Q&A]

 

 

 

 

 

About the author

Krunal Rajput

Hey, I am Krunal Rajput. The Man Behind CivilJungle. I started this site to spread knowledge about Civil/Mechanical/Electrical Engineering. I am a Degree Holder in Civil Engineering.

Add Comment

Click here to post a comment